![]() |
|
|
|||||||
| Screven Motor Speedway This forum is for subjects relating to Screven Motor Speedway Website:www.screvenmotorspeedway.com |
![]() |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
------------------------------------------------ Body : 1.Any 4 cyl.car Front or Rear Wheel Drive. 2.No All Wheel or 4x4 Wheels allowed. 3. No rear steer cars allowed Chassis : 1.stock factory front to rear 2.no re-inforcing or push bars,no bars past dash of car 3.no racing springs 4.factory suspension set up. 5. NO ADJUSTMENT ALLOWED -NO BENDING SPRING BUCKETS,FRONT END ETC. NO DRILLING BRAKE CALIBERS ABSOLUTELY NO MODIFICATIONS 6.Special Note: 1.a 2x2 channel or flat plat steel can be welded @bottom and top to each side of frame to hold radiator only. 2.1 ft. length of 4x4 channel or 4x4 solid plate(total 1ft. lenght) can be welded to frame horns up front with a min. 6 " flat plate welded onto to hold bumper or aftermarket noisepiece. 3.no tubular piping of any kind upfront. Engine: 1.stock production for car. must appear stock externally from the factory.No internal tech is required. 2.air conditioning or altenators can be removed. 3.No cold air intakes 4.no turbos allowed. 5.Gm or Ford production cars must run genuine products meaning 2300 fords must run stock motorcraft carb no header---unless it's factory production for make of car. 6. mufflers are not required Roll Cage: 1.4 point min-6 point ok to extend past fuel tank 2.max. 3 driver door bars 3.min. 2 passenger door bars 4.no bars past firewall 5.min thickness 0.90 (no exhuast or fence post tubing) 6.NO MIRRORS/NO RACING RADIOS Tires: 1.Dot common street tires only/can be mixed or matched for stagger 2.No snow tires/racing recaps or racing tires allowed(no hoosiers or American racers of any kind. Wheels : 1.Factory production for that make of car only 2.No spoke wheels or taller in height, etc allowed ! Last edited by screven motor speedway; 10-09-2009 at 12:48 AM. |
|
#2
|
||||
|
||||
|
thanks Redd, these seem very simple, not hard to understand, not alot of room for grey area, let the building begin
![]() ![]() ![]() ![]() ![]() :yin g_yang![]()
|
|
#3
|
||||
|
||||
|
Sounds good. We shall see you for this race.
|
|
#4
|
|||
|
|||
|
Thats what i needed to know. thanks!
|
|
#5
|
||||
|
||||
|
so you can do anything to the motor as long as it looks stock from the outside???
A 4-cylinder mustang can really be built and still look stock from the outside!!!! |
|
#6
|
|||
|
|||
|
i thought the stock carb rule(motocraft)CARB ONLY
WOULD EQUAL UP-------- IT'S EARLY ENOUGH-------I WILL DO TO 2300' LIKE WE DO OUR MINI STOCKS PULL LIFTER TO CHECK FOR HYD. CAM. ---------------------------------------------------------------- |
|
#7
|
||||
|
||||
|
yea the stock carb on the 2.3 is a dog, build that mustang if you want but with a stock carb you don't have a chance.
|
|
#8
|
|||
|
|||
|
Take these rules on top !
|
|
#9
|
||||
|
||||
|
Noticed you edited the rules. Rule number 3 under body is new.
Which chicken sh!t complained about my car? Tried to sneak that by without drawing any attention to it huh? It comes factory. Maybe I will complain about cars that have a better power to weight ratio. Guess the joke is on the complainer because Im using the volkswagen for this race. Is that going to be a rule next year or is someone just scared of getting beat in the money race? |
|
#10
|
||||
|
||||
|
I guess I didn't look close enough, but I thought that was always the rule. Maybe I saw it in some other track's rules.
The way I run, my car must have rear steer, too - and somebody else is driving it! Last edited by dblnaught; 10-27-2009 at 09:31 PM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|